When the wireless router is ready, press the Maintenance button 12 times. Please refer to your wireless router's documentation for instructions on accessing these settings. You will need to access your wireless router's internal settings to enter the PIN code shown on the Network Configuration Page. ![]() The Network Configuration Page including the PIN code will be printed. ![]() When the LED (B) lights up as shown, press the Color button (C). Press the Maintenance button (A) 11 times. Follow the instructions below to connect your printer to the network using this method. If the problem is not resolved, perform setup with the Setup CD-ROM or perform it according to the instructions on our website.Your PIXMA MP495 can be connected to a wireless network via the WPS PIN code method. Some programs will enable a firewall by default.Ĭheck14 When using a router, connect the machine and computer to the LAN side (same network segment). If using any programs that switch the network environment, check their settings. If the warning message appears, set the security software to always allow access. If the firewall function of your security software is turned on, a message may appear warning that Canon software is attempting to access the network. Make sure that the computer can communicate with the access point over the wireless LAN.Ĭheck12 Make sure that Enable bidirectional support is selected in the Ports sheet of the properties dialog box of the printer driver.Ĭheck13 Make sure that the firewall of the security software is disabled. Place the wireless station as far away from the interference source as possible.Ĭheck11 Make sure that the network settings of the computer are correct. microwave oven) using the same frequency bandwidth as the wireless station is placed nearby, the device may cause interference. 50 m from the access point.Ĭheck10 Make sure that there is no source of radio wave interference in your vicinity. The access point is located indoors within the effective range for wireless communication. Adjust the location of the devices.Ĭheck9 Make sure that the machine is not placed far away from the access point. Wireless communication between different rooms or floors is generally poor. Refer to the instruction manual provided with the access point or contact its manufacturer to check the access point settings, and then modify the machine settings.Ĭheck8 Make sure that there is no obstruction. When the Printer Driver Is Not Associated with a PortĬheck7 Make sure that the network settings in the machine are identical with those of the access point. Select Associate Port on the Settings menu, then associate the port with the machine. ![]() When No Driver is displayed under Name in IJ Network Tool, there is no association. If not, perform setup with the Setup CD-ROM or perform it according to the instructions on our website.Ĭheck5 When using IJ Network Tool, click Update to search for the machine again.Ĭheck6 When searching for a machine over a network, make sure that the machine is associated with the port. ![]() When you set up the wireless LAN connection or change the wireless LAN settings using IJ Network Tool through USB connection, make sure that the machine is connected to the computer with a USB cable securely.Ĭonnecting the Machine to the Computer Using a USB CableĬheck4 Make sure that the machine setup is completed. Wireless LAN is enabled and the Wi-Fi lamp is lit.Ĭheck3 When the machine is connected to the computer temporarily using a USB cable, make sure that the USB cable is connected properly. Press and hold the Stop button until the Alarm lamp flashes 18 times. Follow the procedure below to enable the wireless LAN. If the Wi-Fi lamp is off, the wireless LAN is disabled. The Machine Cannot Be Detected in the Wireless LANĬheck1 Make sure that the machine is turned on.Ĭheck2 Make sure that the Wi-Fi lamp is lit on the operation panel of the machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |